Rust Convertor

Properties of the Rust Convertor

• Application temperature: max 80°C, peak 150°C
• Dust dry after approximately 30 minutes
• Leave to dry for 5 hours between coats

(Figures given for information only, actual times will depend on the temperature, paint thickness, humidity etc)

• Vapour pressure at 20°C: 4 bar
• pH: 4 - 4.5
• Spray flow: 0.8 g/sec.

Specifications of the Rust Convertor 

Composition
Binders: blend of polyvinyl butyral, resins and solvents, free from heavy metals and mineral acids
Colour: clear brown liquid, on metal it turns dark blue/black once dry
Propellant: dimethyl ether

Health and safety

Safety data sheets are available free of charge on the internet: www.quick-fds.com.
CLP labelling with four pictograms.

DANGER
H222 Extremely flammable aerosol.
H229 Pressurised container: May burst if heated.
H319 Causes serious eye irritation.
H336 May cause drowsiness or dizziness.

Instructions for use

• Shake thoroughly before use.
• Remove any paint and rust residues with a metal brush or sander. The surface must be clean, dry and free of grease. When using outdoors, remove any moss or algae present on the surface. Cover the surrounding areas.
• Spray at a distance of 25 cm from the surface.
• Apply several light coats (+/- 4 coats).
• Leave to dry for approximately 20 minutes between coats.
• Once the final coat is completely dry, it is recommended to sand the surface to improve adhesion.